本帖最后由 xyp114 于 2017-8-20 22:23 編輯
老鐵666！必須支持一波！
但怎么做也沒能成功
樓主能指導下嗎？
[0.380744 Inits done]
sINFeOc:u r e tBaLs3k- 1s:t artI!ni
tializing ruhnitgihm et assrvices
WARNING: No OPTEE provided by BL2 boot loader
ERROR: Error initializing runtime service opteed_fast
INFO: BL3-1: Preparing for EL3 exit to normal world
INFO: BL3-1: Next image address = 0x1000000
INFO: BL3-1: Next image spsr = 0x3c9
U-Boot 2015.01-svn120264 (Oct 27 2016 - 15:32:33)
DRAM: 1 GiB
Relocation Offset is: 36ed0000
gpio: pin GPIODV_24 (gpio 43) value is 0
gpio: pin GPIOAO_3 (gpio 103) value is 1
register usb cfg[0][1] = 0000000037f63e08
vpu: error: vpu: check dts: FDT_ERR_BADMAGIC, load default parameters
vpu: clk_level = 7
vpu: set clk: 666667000Hz, readback: 666660000Hz(0x300)
boot_device_flag : 1
Nand PHY Ver:1.01.001.0006 (c) 2013 Amlogic Inc.
init bus_cycle=6, bus_timing=8, system=5.0ns
NAND device id: 2c 64 44 4b a9 0 0 0
detect NAND device: B revision NAND 8GiB MT29F64G08CBABA
new oob mode
bus_c=6,bus_t=8,sys=4.0ns,T_REA=16,T_RHOH=15
show_phydev_list
0: nfbootdetect new nand here and new_type:50
NAND CKECK:arg nbbt: valid=1, blk=5, page=0
NAND CKECK:arg fbbt: valid=1, blk=6, page=0
outside dtb: 0000000000000000
using dtb on nand
amlnf_dtb_init_partitions: probe.
NAND CKECK:arg ndtb: valid=1, blk=8, page=99
NAND CKECK:arg ncnf: valid=1, blk=7, page=0
aml_key_init probe.
NAND CKECK:arg nkey: valid=1, blk=10, page=0
boot_device_flag 1
NAND CKECK:arg nenv: valid=1, blk=4, page=135
nfboot : 0x000000000000-0x000000800000 :partn=0:single_chip single_plane
nfcache : 0x000006800000-0x000029000000 :partn=2:single_chip multi_plane
nfcode : 0x00002f800000-0x000053800000 :partn=9:single_chip multi_plane
nfdata : 0x000083000000-0x00017d000000 :partn=3:single_chip multi_plane
(nfboot) bad blks 0
(nfcache) bad blks 0
(nfcode) bad blks 0
(nfdata) bad blks 0
amlnf_logic_init() start
(nfcache), size:29000000
nftl version 1.01.001
size_in_blk 164; total_block 163;
nftl start: size 163, free 19
-blks(163), total_blocks(144)
(nfcode), size:53800000
nftl version 1.01.001
nftl start: size 334, free 34
-blks(334), total_blocks(300)
all block full!!
current block: 168
amlnf_logic_init() done
MMC: aml_priv->desc_buf = 0x000000003409bf90
aml_priv->desc_buf = 0x000000003409dfa0
SDIO Port B: 0, SDIO Port C: 1
uboot env amlnf_env_read : ####
In: serial
Out: serial
Err: serial
board id is : 6
hpd_state=0
cvbs performance type = 7, table = 1
[store]To run cmd[amlnf dtb_read 0x1000000 0x40000]
cmd dtb_read:
amlnf_dtb_read: ####
262144 bytes dtd_read : OK
dwmac.c9410000
Error: dwmac.c9410000 address not set.
wipe_data=successful
wipe_cache=successful
upgrade_step=2
reboot_mode=cold_boot
[CANVAS]addr=0x3d800000 width=5760, height=2160
[BL31]: tee size: 0
-------------mac=9C:62:AB:10:CD:FC-----------------
IR init done!
gpio: pin GPIOH_6 (gpio 55) value is 1
Hit any key to stop autoboot: 0
ee_gate_off ...
## Booting Android Image at 0x01080000 ...
reloc_addr =340c6490
copy done
Single dtb detected
load dtb from 0x1000000 ......
Uncompressing Kernel Image ... OK
kernel loaded at 0x01080000, end = 0x0200e810
Loading Ramdisk to 33c36000, end 33ebd9b4 ... OK
Loading Device Tree to 000000001fff4000, end 000000001ffffed6 ... OK
Starting kernel ...
uboot time: 2846243 us
[ 0.000000@0] Initializing cgroup subsys cpu
[ 0.000000@0] Initializing cgroup subsys cpuacct
[ 0.000000@0] Linux version 3.14.29-svn119947 (root@ubuntu) (gcc version 4.9.2 20140904 (prerelease) (crosstool-NG linaro-1.13.1-4.9-2014.09 - Linaro GCC 4.9-2014.09) ) #1 SMP PREEMPT Wed Oct 26 19:13:31 CST 2016
[ 0.000000@0] CPU: armv71 Processor [410fd034] revision 4
[ 0.000000@0] bootconsole [earlycon0] enabled
[ 0.181217@0] tv_vout: [tvout_get_of_data] failed to get ext_switch_pin!
[ 0.688734@0] amlogic-new-usb3 d0078080.usb3phy: This phy has no usb port
INFO: HDCP22 key read fail!
INFO: p1d 0
INFO: pd1 0
[ 0.858265@3] aml_sysled_dt_parse: faild to get active_low
[ 1.252798@3] aml_snd_m8_card aml_m8_snd.48: ASoC: no source widget found for LOUTL
[ 1.254794@3] aml_snd_m8_card aml_m8_snd.48: ASoC: Failed to add route LOUTL -> direct -> Ext Spk
[ 1.263669@3] aml_snd_m8_card aml_m8_snd.48: ASoC: no source widget found for LOUTR
[ 1.271181@3] aml_snd_m8_card aml_m8_snd.48: ASoC: Failed to add route LOUTR -> direct -> Ext Spk
[ 5[ 1.662196@3] init: Failed to open /sys/devices/d0074000.emmc/mmc_host/emmc/emmc:0001/block/mmcblk0/capability(No such file or directory)
[ 2.673941@1] init: init.mtk.rc: 105: ignored duplicate definition of service 'ap_daemon'
[ 5.620588@0] init: mount none to target failed
[ 5.677464@0] init: cannot open '/initlogo.rle'
[ 5.678822@0] init: mount none to target failed
[ 5.687317@0] init: property 'ro.serialno' doesn't exist while expanding '${ro.serialno}'
[ 5.689833@0] init: cannot expand '${ro.serialno}' while writing to '/sys/class/android_usb/android0/iSerial'
[ 5.699774@0] init: property 'ro.serialno' doesn't exist while expanding '${ro.serialno}'
[ 5.707784@0] init: cannot expand '${ro.serialno}' while writing to '/sys/class/android_usb/android0/iSerial'
[ 5.717709@0] init: property 'ro.serialno' doesn't exist while expanding '${ro.serialno}'
[ 5.725721@0] init: cannot expand '${ro.serialno}' while writing to '/sys/class/android_usb/android0/iSerial'
[ 6.892799@0] healthd: No charger supplies found
[ 6.895910@0] init: cannot find '/system/bin/instabootserver', disabling 'instaboot'
[ 6.904969@0] init: cannot find '/system/bin/configserver', disabling 'configserver'
[ 6.915192@0] init: cannot find '/system/bin/ctcgroupprop.sh', disabling 'ctc_group_prop'
[ 6.917884@0] init: cannot find '/system/bin/iptvserv.sh', disabling 'IptvServ'
[ 6.927811@0] init: cannot find '/system/bin/RootShellServer', disabling 'root_shell'
[ 6.934284@0] init: cannot find '/system/bin/sytr069.sh', disabling 'sy_tr069'
[ 6.943532@0] init: cannot find '/system/bin/tee-supplicant', disabling 'tee-supplicant'
[ 6.949837@0] init: cannot find '/system/bin/mtkbt', disabling 'mtkbt'
[ 7.000868@0] init: property 'ro.usb.vendor.string' doesn't exist while expanding '${ro.usb.vendor.string}'
[ 7.005959@0] init: cannot expand '${ro.usb.vendor.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/vendor_string'
[ 7.017874@0] init: property 'ro.usb.product.string' doesn't exist while expanding '${ro.usb.product.string}'
[ 7.027324@0] init: cannot expand '${ro.usb.product.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/product_string'
[ 7.093084@0] init: property 'ro.usb.vendor.string' doesn't exist while expanding '${ro.usb.vendor.string}'
[ 7.097219@0] init: cannot expand '${ro.usb.vendor.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/vendor_string'
[ 7.110400@0] init: property 'ro.usb.product.string' doesn't exist while expanding '${ro.usb.product.string}'
[ 7.130512@0] init: cannot expand '${ro.usb.product.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/product_string'
[ 7.138535@0] init: property 'ro.usb.vendor.string' doesn't exist while expanding '${ro.usb.vendor.string}'
[ 7.147698@0] init: cannot expand '${ro.usb.vendor.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/vendor_string'
[ 7.162149@0] init: property 'ro.usb.product.string' doesn't exist while expanding '${ro.usb.product.string}'
[ 7.169680@0] init: cannot expand '${ro.usb.product.string}' while writing to '/sys/class/android_usb/android0/f_mass_storage/product_string'
root@cucc_sichuan:/ # [ 7.301504@0] init: property 'sys.powerctl' doesn't exist while expanding '${sys.powerctl}'
[ 7.304225@0] init: powerctl: cannot expand '${sys.powerctl}'
[ 7.310140@0] init: property 'sys.sysctl.extra_free_kbytes' doesn't exist while expanding '${sys.sysctl.extra_free_kbytes}'
[ 7.321968@0] init: cannot expand '${sys.sysctl.extra_free_kbytes}' while writing to '/proc/sys/vm/extra_free_kbytes'
[ 7.331977@0] init: cannot find '/system/bin/instabootserver', disabling 'instaboot'
[ 7.340039@0] android_usb: Cannot enable 'adb' (-22)
[ 7.345185@0] android_usb: Cannot enable 'adb' (-22)android_usb: Cannot enable 'adb' (-22)
root@cucc_sichuan:/ # cd /storage/external_storage/sda1
/system/bin/sh: cd: /storage/external_storage/sda1 : No such file or directory
鍵入cd/storage/external_storage/sda1 命令，
/system/bin/sh: cd: /storage/external_storage/sda1 : No such file or directory
2|root@cucc_sichuan:/ # cd /storage/external_storage/sda1
/system/bin/sh: cd: /storage/external_storage/sda1 : No such file or directory
|
網站導航
樓主: hao501802766
[復制鏈接]
發表于 2017-8-2 10:57
樓主
znds.com 